In the interest of increased safety and productivity, the modern repair or assembly shop needs to insure that bolts are tightened both evenly and to the correct torque level. Current standard procedure requires two steps; snug the lugs with an impact gun, then use a torque wrench. Problem is, how do you know the job is done or done right? With "1000 ft/lbs of nut busting torque", most lugs get overtightened by the impact tool before the torque wrench ever touches them. With clicker type torque wrenches, many techs seriously overtighten bolts and nuts because they dont stop pulling when the wrench clicks. Add distractions, tech turn-over and limited training resources, and the critical job of tightening nuts and bolts properly often gets overlooked. This can spell disaster in terms of safety and high rework costs. The time has come to address this problem; Select-Torque is the answer. Select-Torque is simple. Simple to program, simple to operate. No complex computor
Epro-Data-Torq-Select-Torque-Contolled Impact Wrench